The ink feed is high
Ink strength is low,change to high strength ink for better feed
Improper setting of inking & dampening roller
Set the plate inking rollers with less pressure to the distributor & plate
Plate inking roller too hard
Recommended hardness 25 deg-30deg shore for better results
Poor splitting, water runs into the inking unit
Check ink consistency & formulation to avoid splitting
Rubber rollers too smooth
Deglaze the rollers for better results
The ink is accepting too much dampening solution
Check ink formulation and use accordingly for better dampning
The water feed to the printing plate is high.
It is to be set just above the point of ink catch up on plate but always with ink marking on the plates leading edge
For more information, please contact us.
