Cylinder is too deep
Re-etch or replace cylinder
Ink is not wetting stock properly
Change blade angle, then change solvent selection
Ink might be printing chracteristics of substrate
Check alternate substrate for smoother surface
Ink or substrate is too cold
Vary temperature of ink and substrate. Allow to warm to room temperature
Ink viscosity is too high
Ink viscosity is too low
Increase ink viscosity
Make sure solvent blend is correct for resin balance
Check solvents(blends) for accuracy - run GC
Paper stock is too dry
Introduce moist air
Pigment selection is poor
Reformulate ink
Press returned ink is unusable
Increase resin soldis. Use fresh ink
Press speed is too low
Increase press speed
Print impression is excessive
Reset for lighter impression
For more information, please contact us.
